Andy from Wiltshire Windscreens came over to fit the Windscreen following some issues over the last fortnight around the weather and a rubber seal from a supplier which did not fit. This time however, the weather was good and all the kit fitted (with a bit of grunting, and a minor modification) and the windscreen is now in and looking fantastic. I have to hand it to Andy, he did a fine job, was great company and charged a very reasonable fee.

• 

• 

• 

• 

Paul had also come up to help me for the day. I wanted him to look at the o/s headlamp since I could not fit the bevel and it was causing me annoyance. We played around with the other unit (the one not fitted) and sort of worked out how it went on. We concluded that the unit was too tight to the seal to allow the bevel to hook up to the securing lip, so reluctantly removed it for a refit. I had used very short bolts because I didnt want the bolts protruding into the wheel arch, but on relfection I had gone too short and now the assembly didn’t work. While inspecting the lamps, Paul was recalling his days working on his Triumph 2500 that he had in his youth. Helpfully, he could still remember how the lamps went together and he did a good job dismantling and cleaning the unit which then looked much more presentable. After a quick visit to Halfords to buy some bolts, we assembled the lamp units in situ and to my delight, the bevels fitted. We weren’t completely sure that the lamps are as securely fitted as they need to be, but this was a step forward and like a lot of things on the car, once something is on, it can be endlessly fettled, and probably will be.

Next job was to refit the grille which had to be removed to maximise the reach of the crane for the engine install. Refitting the grille was relatively easy, although its a tight fit and it was better to do this now, than leave it in the kitchen to annoy Helen.

On a roll from our success, I asked Paul to work with me on sorting the bonnet release which wasn’t operating. I wasn’t happy with the cable routing, so we altered it by hanging a clip off the last wing bolt which held the cable more securely. Having Paul’s input, as well as extra pair of hands to hold the cable while I tightened the securing nut was invaluable and on testing, the bonnet release worked as it should.

• 

• 

• 

So a really successful day and some more milestones achieved. To quote the Beatles, I get by with a little help from my friends.